These covers provide a better fit than other types of pool covers. They also provide extra security measures whilst allowing you and your family to extend your pool season by months every year. Benefits of Our Flexible Pool Coversįlexible in design and installation, these value-for-money swimming pool covers save water, chemicals, money and time. These are designed and manufactured to suit most pool shapes and budgets. Today, Elite Pool Covers offers a wide range of high-quality, semi- or fully-automated flexible swimming pool covers. Since 1989, Elite has been at the forefront in the design and manufacture of automatic pool covers in Australia. In this regard, nothing beats the automated flexible swimming pool cover systems by Elite Pool Covers. Note : The pre-assembled hardware on the axis takes into account the motors dimensions.Swimming pool covers should be flexible, energy-saving, safe, secure and easy to use. If the pool itself is not straight, this will also cause the shutter covers slats to be out of line. If this is the case, unrolling will equally cause friction with pool wall with the shutter cover. This causes the layers of slats to be out of line. Incorrect positioning will provoke the incorrect rolling of the cover. The straps should be fitted in their respective supports which can be adjusted in relation to the shutter cover. The first module of the slats is equipped with weaved nylon straps 50mm wide. Once the shutter cover has been assembled, it should be fixed to the rolling axis. To simplify assembly, the slats should be placed, by module, on water.įixation of the shutter cover on the axis This module should be positioned at the extremity of the shutter cover which is opposite to the rolling axis. One of the modules is equipped with obliged security straps. The other slats are delivered in modules of 3 or 6 elements. The first module of the shutter is delivered with fixation straps attached to the axis. The slats must be stocked in the shade, with an air temperature lower than 40°c. The assembly of the shutter can only be undertaken if there is water in the pool. If this option is used it must be installed in a position where the pool is visible during each opening and closing unit.ĭuring the installation, if the key control cable terminals are inverted and the shutters action does not correspond to the open and close position on the box, cross the cable terminals "F and O" in the control box. Internal installation within the reccomended protection volumeįorwards/backwards and on/off command by holding the key contact in position (Norm NF P90-308).įorwards/backwards and on/off command by holding the key contact in position to open and close the shutter by one impulsion on the key (Norm NF P90-308).Estimated rolling time for pools measuring 8 x 4m : 1'30 min.Motor coupling 150nm or 250nm depending on pool size.Sealed motor contained in the axis with limit management Rolling time for pool 8 x 4m : 1'30 min.Delivered pre-assembled on axis supports.Sealed motor contained in the axis without limit management Diameter : 140 or 155mm for pools greater than 10 x 5m.Material : reinforced andonised aluminium.Fixations : 2 x 4 stainless steel screws m8 x 90 on brass pegs.Material : stainless steel 304, thermo laquered in white,.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |